Repair and Reinforcement Systems / Cement Based Grouting Mortar
GRT 20 is a cement based, single component, flowable, ready to use grout mortar that expands to sufficiently counteract the plastic shrinkage normally associated with cement grouts.
Fields of Application
- Anchoring the machine feet,
- Rail beds,
- Columns in pre-cast construction,
- Concrete anchors,
- For pile cap reprofiling and encapsulation
- To fill in cavities, gaps and recesses,
- Bearing plates.
Features and Benefits
- Single-component and ready to use product, mixed with only water.
- Adjustable viscosity, applicable easily by pouring into mould.
- Has high strength.
- Has good flow characteristics.
- Resistant to impact.
- Protects to steel against corrosion.
- Prevents shrinkage after curing.
Preparation of Substrate
Application surface must be sound, clean and clean off materials which prevent bonding, such as dust, oil, rust and remove loose pieces. Concrete surfaces must be saturated with water before application. Immediately before pouring remove all excess or standing water from within any formwork.
25 kg bag GRT 20 is poured slowly into 3 - 3,5 liters of clean water under low speed mixer for 3-4 minutes until obtaining homogenous mixture. Mixing water must be clean and free of salt and lime. Mixture should be applied within 40 minutes at 20°C. GRT 20 is only applied for filling applications as 10-30 mm thickness for each layer. If required more thickness surface, aggregate can be added to grout. In case of adding extra aggregate to the grout, due to the reduction of cement percentage, performance can be reduced approximately 20-40 %. During the application surface and ambient temperatures should be between +5°C to +30°C. It is not recommended to apply on windy, rainy and frost days.
For 1 litre fresh mortar, approximately 2,0 kg powder.
25 kg kraft bag
Polyester Based Chemical Anchor - POLY 308
Epoxy Based, Two Component, Solvent-Free, Anchoring and Adhesive Mortar - EPOX 305
Cement Based, Flowable and Fast Setting Grout Mortar - GRT 25
Cement Based Grouting Mortar - GRT 20
Cement Based, Repair Mortar and Finishing Coat - REPAMERK 2
Polyurethane Based, Two Component, Injection Resin - PUR IN 24
Cement Based, Structural Repair Mortar - REPAMERK 301
Corrosion Protection and Bonding Agent Mortar - REPAMERK 325
Epoxy Based, 3 Component, Solvent-free, Repairing and Filling Mortar - EPOX 310
Epoxy - Acrylate Based Chemical Anchor - EPOX 307
Cement Based, Repair Mortar for Non-Structural Repairs - REPAMERK 1
Epoxy Based, Two Component, Solvent Free, Adherence Between Old and New Concrete - EPOX 311
Mold (Fungus) Preventive Impregnation Primer - WALL CL 100
Reinforcing Purpose, Epoxy Based Injection System - EPOX IN 25